Rear jack for RCF 4Pro 8003-S

[Evolved]

So there are 4 jacks on the top and 2 on the bottom. I can gather what the two on the top are for but what abut the ones below?
What type are they. I think I know what they are but can't confirm it. What is Stereo c. ?

[windspeed36]

Stereo input and output

[drzinc]

First set of jacks are combo inputs (xlr & 1/4 inch) Below that are outputs for tops and these are crossed over so that bass does not go to the tops.

Input signal: bal / unbal
Input connectors: Stereo c. xlr-jack
Output connectors: Stereo xlr
Input sensitivity: - 2 dBu / +4 dBu

[Evolved]

First set of jacks are combo inputs (xlr & 1/4 inch) Below that are outputs for tops and these are crossed over so that bass does not go to the tops.

Input signal: bal / unbal
Input connectors: Stereo c. xlr-jack
Output connectors: Stereo xlr
Input sensitivity: - 2 dBu / +4 dBu

I need to find the correct cable type from those jacks to the tops. Tops are an XLR.
Sorry I feel like an idiot. I see what I think are 6 jacks 4 on the top and 2 on the bottom. ...

[drzinc]

I need to find the correct cable type from those jacks to the tops. Tops are an XLR.
Sorry I feel like an idiot. I see what I think are 6 jacks 4 on the top and 2 on the bottom. ...

The jacks on the bottom are power in and out the in is from the wall (plug) the second is an out for powering a second sub (great for coupling the subs) this way you would only have to run one one power cord from the wall to power two subs by using a power jumper cable.

As for sub to tops these are standard male to famale xlr cables.

[Evolved]

The jacks on the bottom are power in and out the in is from the wall (plug) the second is an out for powering a second sub (great for coupling the subs) this way you would only have to run one one power cord from the wall to power two subs by using a power jumper cable.

As for sub to tops these are standard male to famale xlr cables.

That's what I needed clarified. I though the power jack was sitting above the power switch.

[ampnation]

RTFM
product page... http://www.rcf.it/en_US/professional...ms/4pro-series
direct manual link... http://www.rcf.it/c/document_library...groupId=216492

[Evolved]

I just placed an order for one of these.

[light-o-matic]

I though the power jack was sitting above the power switch.

That's the fuse holder.

[Evolved]

Advice on power. Do I need a power conditioner? If using one of these? Should I keep this plugged into a separate socket?
I am thinking I can run this and the 312A's On one power socket then the decks/mixer on another. Or is it possible to use them both from one? Yet maybe not a good idea?