OK, so the bar I play at has this gear that I want to properly set up, but have a lot of learning to do.
JBL SR4719X (dual 18" Subwoofer) http://www.jblproservice.com/pdf/SR-...es/SR4719X.pdf
Crown MicroTech 2400 - http://www.crownaudio.com/pdf/legacy/136733.pdf
DBX Driverack 260 - http://www.dbxpro.com/260/
QSC K12's - http://www.qscaudio.com/products/spe...series_k12.php
So anyways, this is my first time messing with a driverack, and have yet to see if I can use my serial to USB converter to hook it up to my MBP. I bring my own mixer etc (DJM-800, CDJ-400's and more) as theirs sucks. I am usually really good about figuring this stuff out, but I have never set a limiter before. The way I have been told to do it is by "dummy loading" the amp, set it to max, send pink noise through, and check the voltage. Then adjust the limiter to the correct max voltage. Well on the spec sheet it says 1800 watt continuous for the subs, but how do I convert that to Volts when you don't know the amperage? I assume since it is a 4ohm load I may be able to figure it out somehow. V=IR W=VI So since I don't know V or I how do I do it backwards to find out V from having just R and W?
And then How the fuck do I set this damn DBX up once I find the values I need ?? GRR
Bookmarks