Results 1 to 3 of 3

Thread: QSC plx 3402 JBL 2242 H

  1. #1

    QSC plx 3402 JBL 2242 H

    Wondering if I could run 3 JBL’s 2242’s 800w each with 1 amp - QSC PLX3402? If anyone could recommend bridge,?Thanks.


    Sent from my iPhone using Tapatalk
    Last edited by Jovan Morales; 09-06-2019 at 05:03 PM.

  2. #2
    Quote Originally Posted by Jovan Morales View Post
    Wondering if I could run 3 JBL’s 2242’s 800w each with 1 amp - QSC PLX3402? If anyone could recommend bridge,?Thanks.


    Sent from my iPhone using Tapatalk
    You can run two of them bridged on one plx3402, you'll be able to reach the maximum program power of the drivers in that mode. Three drivers is too much because the impedance will be too low. I have four of those amps and they are very reliable but they also get pretty hot at 2 ohms (4 ohms bridged) I would not go below that.

  3. #3
    Quote Originally Posted by light-o-matic View Post
    You can run two of them bridged on one plx3402, you'll be able to reach the maximum program power of the drivers in that mode. Three drivers is too much because the impedance will be too low. I have four of those amps and they are very reliable but they also get pretty hot at 2 ohms (4 ohms bridged) I would not go below that.
    Many thanks



    Sent from my iPhone using Tapatalk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
a