-
Member
HELP!! ADJ Dotz Par System
I had one Dotz Tpar System that worked wonderfully. Had a big wedding come up so decided to order a second one and run them in master/slave mode. Seemed simple enough. Both work individually but when I connect with DMX cable and set one to SLAVE MODE it shuts off and does not mimic the first one. The manual says that you set the second one to SLAVE MODE (simple enough) and the first one has to be set to MASTER MODE (see instructions on page 10 it says) but there is NO mention of how to set it to MASTER MODE on page 10 or any other page for that matter.
I'm not wanting to use a DMX controller, just the RF remote. I did notice when powering on one says Software Vol 1.05 and the other says Software Vol 1.07. Could that cause an issue?
-
I think you better contact ADJ support for this question.
I did once, did get great support.
grtz
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
a
Bookmarks