Need help replacing sl1200m3d tonearm wires.

[Crushgroove]

I just received my tonearm replacement wires from KADUSA.

These wires are SUPER THIN! So I'm wondering how to go about this. Here are a few questions/concerns.

-Should I just replace the wire or wires that are damaged?

-Replace all the wires?

-Leave a bit of the original wire at the contacts and splice/terminate there instead of taking all the wire off??

-what grade? Which type of solder wire do I use for this?

-do I need any other special tools???? Lol

Big thanks for any insight or help guys.
I'm looking to try and repair it this weekend.
thanks again

[monomer]

https://www.kabusa.com/arm-rewire.pdf

If you missed it.


Use whatever solder you're comfortable with. I use Kester 44. Replace ALL the wires, leave no remnants of stock. Be sure to pack with cotton if it's not included.

[Crushgroove]

Yup... totally flew past that one. Thanks again for the help, gotta spread the love before I can kick it back your way.

I'm assuming once I get the tonearm assembly off and I can turn the unit upside down the screw(s) underneath near the actual cart should be relatively easy to remove. (I hope.) Thanks again!

[Crushgroove]

I asked DTR to remove this thread, since I noticed it could be covered in my tonearm trouble thread I have going on.
Sorry bout that fellas.

[DTR]

No need to remove the thread, but I'll leave a link to the other thread here

http://www.djforums.com/forums/showt...hnics-1200m3d)

[Crushgroove]

Awesome thank you!