Hey everyone, This is my first post here. I need some help setting up my mixer to traktor. i set up my numark ndx 800's but i cannot get my mixer to control traktor its a numark m2. any help would be appreciated.
Hey everyone, This is my first post here. I need some help setting up my mixer to traktor. i set up my numark ndx 800's but i cannot get my mixer to control traktor its a numark m2. any help would be appreciated.
Do you have Traktor Scratch Pro?
You cannot control Traktor (Scratch Pro) with Numark M2, since it doesn't have midi. The NDX 800s will control Traktor as far as the deck part of the software is concerned.
You need either a midi controller in addition to your Numark, or then a different mixer that has Midi control.
By the way, how did you connect the M2 to your pc?
This runs you through the basic setup...
Click here for mobile viewing.
ok clearly i am retarded. what i meant to say was i connect my numarks to my pc and i have an external soundcard its a numark DJ IO but whenever i try to install the drivers i get an error message.
There are MANY ways to get to paradise, but here's what I think that you're asking:
How can I use my Numark CDX800s to control the decks in Traktor while outputting the audio via the Numark DJ IO sound interface to my Numark M2 mixer?
This will be slightly kludgy setup because you have four line-level sources where your mixer only takes 2 line-level and 2 phono-level sources. As phono-level sources also have an RIAA filter, I don't recommend getting a converter to use them. So here's the rub: you have to choose between mixing CDs and mixing 2-decks in Traktor.
I personally would (and do) mix just Traktor. To do so:
* Connect the CDX800s and DJIO to your computer via USB (load drivers as necessary)
* Connect the DJIO main output and headphone output to your mixer's line-channels 1 and 2 respectively
* Configure Traktor to use EXTERNAL mixing mode and have deck 1 go to main output and deck 2 to go to the monitor output
As an aside, consider selling the DJIO and buying the S4 (if you want Traktor) or the NS6 (if you want ITCH) so that you can use a DJ app WITH your CDX800s.
-KLH
Consider using a different USB port and/or USB cable.Originally Posted by danielpattonjr
-KLH
I hae tried these things and more and still getting the same error message
You downloaded the Win7 32-bit drivers from the Numark site? What error message are you getting when you try to install them?
Yes i downloaded the drivers from numark and the error i get is "unfortunatly the instillation failed" (Error 0x0006)
Posting Permissions
Reply With Quote
Bookmarks