PDA

View Full Version : Ecler Nuo 3 Clean or replace Eq Knobs?



Jason Lintner
10-06-2012, 09:08 PM
Hi Everyone,

Just looking for some advise on the above mixer.
I'm starting to receive some static while turning knobs & though it might be best to replace them, as a temp fix I'll switch some knobs over from the one channel I rarely ever use. Does anyone have any experience with this mixer & knowledge of a good place to purchase the parts? Is it possible that they may just require a good cleaning?

Otherwise, it's been a solid mixer and have been please with the quality.

Thanks

Jay






www.deephouselounge.com

drzinc
10-06-2012, 09:51 PM
Try DeoxIT contact cleaner first.

Jason Lintner
10-07-2012, 08:18 AM
Thanks for the reply, drzinc.
So I might be able to get away with just cleaning these knobs then.
Makes sense, start with inexpensive route first.
Any suggestions for parts if needed?

Estacy
10-13-2012, 07:14 AM
I've had a crackling PFL/MIX knob on my Nuo 3, I used Deoxit faderlube FN5 to clean and lubricate it. works like a charm. figuring how to dismantle the mixer at first is difficult, but once apart every pot is easily accesible. just spray some small bursts in the holes in the ALPS pots. turn the pot 20 times and it should work fine now. Its really easy and quite cheap